KEEP EMC Tests – ESD update

Success!!

We have now finally also passed the ESD tests. We had an issue that the unit would reset during contact discharge to the back ALU-plate.

Turns out that we need to have a rugged washer to penetrate the black anodizing so that the screws mounting the PCB to the plate will connect properly.

So thumbs up, we have a pass on all EMC tests now.

/PA

pa
About

Founder of OpenProducts

Posted in Uncategorized
One comment on “KEEP EMC Tests – ESD update
  1. Kim says:

    The wait is aaaaalmost over;-)

Leave a Reply

Your email address will not be published. Required fields are marked *

*

Blue Captcha Image
Refresh

*