September 14, 2014 at 18:43 #430
I’m attempting fisrt setup, and my OPI has got to Right amd Middle LEDs on solid. No sign of the left LED flashing yet, and it’s been at least 10 minutes.
Is there any indication of how long this takes?
Or is something wrong? Firewall, perhaps? or uPNP not working?
Be it noted, I am paranoid about router settings.
September 14, 2014 at 18:53 #433
Being paranoid is one of the reasons for the OPI to exist…
When the right and middle leds are solid, the left should immediately start to flash. You can either try to run the setup anyway, not that I can explain why, but maybe the “flash” command did not take, or just try to power cycle the unit.
Either way, I would appreciate an update so that we know that we either still have a problem or that we can close the issue.
September 14, 2014 at 19:05 #434
I’m an idiot.
Research in my router settings showed UPnP was off, so I enabled it, and rebooted the OPI. Still no joy.
So I put the OPI on a fixed IP within my local, private, scope and forwarded port 443 to it, manually.
After reloading the setup page (not just <F5> refresh) all tests were passed and setup is now proceeding.
Thanks for the quick reply.
September 14, 2014 at 19:25 #435
Well, I thought it did…
I created a master password, set my op-i name, created my first user (me, of course!) and…
BANG! Unknown error.
Then I discovered that my fixed IP assignment hadn’t taken – assuming that I reassigned the correct MAC address…
Now retrying setup fails at HTTPS access. But this is most likely a problem internal to my network, so I will continue investigating, and report back.
You must be logged in to reply to this topic.